The LED's luminous intensity is proportional to the load current. The circuit is designed to provide a very compact circuit to replace the meter on the 12V power line in some astronomical equipment. This device contains low power heating elements (anti-dew elements) that are not visible in the working condition. However, when the heater is turned on, the LEDs emit a visible light that clearly indicates that they are connected and working.
Circuit analysis is very simple. The voltage across the 22 ohm resistor is the same as the voltage across RSENSE. The current flowing through the 22 ohm resistor is the same as the current flowing through the LED. Therefore, for the parameter values ​​given in the figure, the LED current is equal to 0.05/22 of the load current. When the load current changes from 200 mA to 6.6 A, the LED changes from weak illumination to full brightness (limited to 680 ohm resistance).
If necessary, add another LED with a fixed resistor for comparison. In addition, the histogram display results can be obtained by constructing different examples of the circuit. In these circuit examples, the resistors of 22 ohms are replaced by different resistors, and RSENSE remains unchanged.
The op amp must have an input and output that can reach the positive rail and can withstand a supply voltage slightly above 12V. TI's TLV2731 is ideal for meeting these requirements.
When the load current is 200mA, the LED emits weak light; when the load current increases to 6.6A, the LED emits the brightest light.
XXR offers Heat Shrinkable sleeves with RSBA series, RSBJ series, RSB series, RSY series, RSBAD series and SBZS series.
1. High performance heat shrinkable closure for unpressurized applications or air-blorcking pressurized cable networs.
2. Able to work under an environment of -30 degrees centigradeto +90 degrees centigrade for a long term
3. Suitable for aerial, buried applications
4. It is of super composite fiber structure and secondary sealing, featured by high mechanical strength, strong tearresistant, and strong shrinkage and excellent resistance to weathering.
5. Super heat shrinkable sleeve sealing gel material is composed of several layers of specially blended polymers, adhesives and fiber-reinforcing layer. The fiber-reinforcing layer provides excellent mechanical strength and eliminates the propagation of localized damage that can result from overheating or other errors in installation. Once the closure sleeve has been installed, the composite design of the Super Sleeve sealing gel material provides superior mechanical protection from forces such as impact, abrasion, UV light, and atmospheric contamination
6. The heat shrinkable closure bears excellent leakproofing, moisture-resistance and pressure-containing capacity; The softening point can be up to 130 degrees centigrade, suitable for the area of high ambient temperature.
7. Range of closures to suit all cable sizes
8. Simple and easy to install
Heat Shrinkable Sleeves For Copper Cable
Heat Shrinkable Tubing ,Heat Shrink Wrap Tubing,Heat Shrink Tubing
Chengdu XingXingRong Communication Technology Co.,Ltd , http://www.xxrtx.net