Not only during the Spring Festival, the water purifier should pay attention to maintenance. It can be flushed frequently: the process of taking water from the taps in daily use is to flush the water purifier. It is recommended to open the tap after washing the purified water, and wash away the trapped pollutants in time to keep the water purifier. Higher water flux for longer life.
Backwashing to restore water production: If the water production capacity of the water purifier after rinsing is still relatively small, you can consider backwashing the water purifier.
In the case of running water in the tap water, please open the sewage faucet to drain the sediment, rust, etc. in the water pipe, and then open the purified faucet to use the purified water.
Precautions for long-term use without re-use
If you go out to travel during the Spring Festival or return to your hometown, the water purifier must do some power-off and water-cutting treatments, such as turning off the power supply and the tap water switch. If time permits, the water in the water purifier can be drained. At the same time, the water purifier has not been used for a period of time, and it is prone to various problems such as odor, impurity accumulation, and ultrafiltration membrane drying. When using it, please keep the following points in mind:
1. Open the sewage outlet to remove impurities
Before preparing to use the water purifier again, first open the sewage outlet of the water purifier, and remove the impurities such as sediment and rust inside, so as to avoid blockage of the water purifier.
2. Rinse the water from the water purifier.
It is necessary to rinse the water purifier. If it is not used for a few days, rinse it for 3-5 minutes. If it is more than one week or longer, you need to rinse the water purifier for more than 15 minutes until the water purifier is inside. The remaining water is completely rinsed off.
3. View ultrafiltration membrane ultrafiltration membrane
If you are using an ultrafiltration machine at home, check the ultrafiltration membrane for the following conditions: If the ultrafiltration membrane appears dry, the pore size shrinks. The water purifier will become smaller. At this time, the ultrafiltration membrane cannot be recovered. If this happens, the ultrafiltration membrane will be replaced.
4. Regular filter replacement
Clean the filter element of the water purifier. After cleaning, test whether there is water purification effect. If it is still not, replace the filter element.
At the same time, the water purifier is different from other household appliances, and cannot be cleaned once and for all. It is necessary to clean or replace the internal filter element regularly.
In the life cycle of the water purifier filter, the standard of regular replacement should be strictly implemented to regulate the post-maintenance service of the filter element.
For example, Anzhixing water purifier AZX-2100-50C4, the first stage 5 micron PP cotton filter replacement cycle is about 3-6 months;
The second-stage rod-shaped activated carbon filter is recommended to be replaced in 10-12 months;
The third-stage imported ultrafiltration membrane filter is recommended to be replaced in 20-24 months;
The fourth grade Dow RO membrane filter is recommended to be replaced in about 24 months;
The fifth stage rear activated carbon filter replacement cycle is about 10-12 months.
Of course, the specific replacement time will be determined according to the local water quality. The correct installation and regular replacement of the filter element is mainly to ensure that we are always drinking safe and healthy fresh water.
Low temperature, how to maintain the water purifier
During the Spring Festival, temperatures will still be low in some areas. At low temperatures, it is easy to cause the tap water pipe to burst. If the tap water supply pipe is cracked and water is not used, do not use the water treatment equipment at home.
The correct way is: turn off the water inlet ball valve of the home water purifier, wait for the water to come, open the faucet at home, discharge the large particles such as sand in the water supply pipe, and then open the water ball valve to make the water purifier normal. Work; this can effectively avoid the sediment and rust mixed in the construction process into the water purifier, resulting in a decrease in the production water flow or blockage of the filter element.
If the water purifier is installed outdoors, it must have anti-freeze measures, otherwise it may cause the filter bottle, membrane shell, fuselage, etc. to freeze and crack, and the outdoor water temperature must be stopped when the outdoor temperature is below zero.
The water purifier is installed indoors, and the room temperature must not be lower than 0 degrees, because the volume will expand during the solidification process. If it freezes, it may directly lead to all the pipelines, filter bottles, membrane shells, fuselage, etc. It will burst and water leaks.
General materials of hot dip galvanized Screw Bolt nut is Q235 ,35K ,45# ,35CrMo,etc.According to the engineering requirements, the corresponding different grades Screw bolt nut are selected respectively .Generally ,the high-grade Nut products such as 35K,45# C35CrMo are prreferred for UHV lines, Mainly include :
1) High strength Nut
2)35 Crmo Nut
3) Thinckening of Nut
4) Enlarged bore Nut
5) Fine buckle Nut
6)Slotted Nut
7)Flange Nut
8) Lock Nut
According to strength grades ,there are 4,6,8,8.8,10.9grade ,for construction of differeent fields ,can use hot dip galvanized Flange nut ,Helix nut ,or other nuts .
Flange Nut,Carbon Steel Nut,Lock Nut,Stainless Steel Nut,Helix Nut
BAODING JIMAOTONG IMPORT AND EXPORT CO., LTD , https://www.chinagroundscrew.com